Final Year
Get Started
Preview only — this sample cannot be downloaded or printed.
Final YearPreview only

A project submitted to the Department of Mechanical Engineering

Design and Construction of a Manual Block Moulding Machine

By

Naledi Dlamini

U/2013/ABC/0162

In partial fulfilment of the requirements for the award of a Bachelor's degree

Supervisor: Dr. M. N. Dlamini

2023

Abstract

Designs a low-cost manual block moulding machine made from mild steel, with a hand lever for compaction. Includes design calculations, fabrication, and test of blocks produced. The study is organised into five chapters covering the introduction, review of related literature, system analysis and design, data presentation and analysis, and the summary, conclusion and recommendations.

Table of Contents

Chapter One: Introduction

  1. 1.1 Background to the Study4
  2. 1.2 Statement of the Problem6
  3. 1.3 Aim and Objectives of the Study8
  4. 1.4 Research Questions10
  5. 1.5 Research Hypotheses12
  6. 1.6 Scope of the Study14
  7. 1.7 Limitations of the Study16
  8. 1.8 Operational Definition of Terms18

Chapter Two: Literature Review

  1. 2.1 Conceptual Review16
  2. 2.2 Theoretical Framework18
  3. 2.3 Empirical Review of Related Studies20
  4. 2.4 Gap in Literature22
  5. 2.5 Summary of Literature Review24

Chapter Three: Research Methodology

  1. 3.1 Research Design28
  2. 3.2 Area of the Study30
  3. 3.3 Population of the Study32
  4. 3.4 Sample and Sampling Technique34
  5. 3.5 Instrument for Data Collection36
  6. 3.6 Validity and Reliability of the Instrument38
  7. 3.7 Method of Data Collection40
  8. 3.8 Method of Data Analysis42

Chapter Four: Data Presentation and Analysis

  1. 4.1 Data Presentation40
  2. 4.2 Test of Hypotheses42
  3. 4.3 Discussion of Findings44

Chapter Five: Summary, Conclusion and Recommendations

  1. 5.1 Summary of Findings52
  2. 5.2 Conclusion54
  3. 5.3 Recommendations56
  4. 5.4 Suggestions for Further Studies58

References

Appendices

Final YearPreview only

Chapter One: Introduction

1.1 Background to the Study

Designs a low-cost manual block moulding machine made from mild steel, with a hand lever for compaction. Includes design calculations, fabrication, and test of blocks produced.

1.2 Statement of the Problem

Affordable manual block moulding machine for small-scale Nigerian builders. Existing approaches remain limited in reach, accuracy and ease of use, which creates the gap this study addresses.

1.3 Aim and Objectives

The aim of this study is to design and construction of a manual block moulding machine. The specific objectives are to:

  1. review existing literature and systems related to the study;
  2. collect and analyse data using a suitable research design;
  3. evaluate the results against the stated problem;
  4. make recommendations for practice and further research.

1.4 Scope of the Study

Introduction: background to manual block moulding machines, statement of the problem (imported block moulding machines are unaffordable for small Nigerian builders), aim and objectives, research questions, scope, significance of the study, and definition of terms.

Chapter Two: Literature Review

Literature Review: theoretical framework, review of related works on manual block moulding machines, gaps in existing studies, and a summary positioning this project. Literature Review: theoretical framework, review of related works on manual block moulding machines, gaps in existing studies, and a summary positioning this project.

Chapters 2–5 are not part of this preview.